Autocad drawing in feet

Specify the first corner of the rectangle. Enter D for Dimensions. Enter the length. Enter the width. Specify the other corner. Note: You are restricted by the length and width values. Under AutoCAD Architecture toolset, select Allow general object snap settings to act upon wall justification line. To Draw Walls Select a wall tool. Specify the wall segment start point. Specify the wall segment endpoint.

It can be used for making simple lines in the drawing. It is the command used for making a circle in AutoCAD. This command can be used to make a Polyline in your drawing. This command will make a rectangle in AutoCAD.

The legend or key, usually located near the lower right-hand corner of the drawing, should explain all of the symbols on the drawing. Look at the title block. Please select the Accept as Solution button if my post solves your issue or answers your question. I am checking back to see if my post or others helped you with your problem.

Please add a post with how you decide to proceed and your results so other Community members may benefit. Please hit the Accept as Solution button if a post or posts solves your issue or answers your question.

This answer does not help. What I am trying to do should be simple. But everything in this program - now after I have purchased it - is not intuitive. I am trying to draw a house layout.. So all I want to do is to draw a room say 12 feet x 15 feet. There is no straightforward way to do this. Instead I am forced to put in a starting point and then an opposite end point.

Well why do I even care about those points. The coordinates refer to implementation of the rectangle - I am a user I want to draw a simple box in feet and see that as I move the cursor. I have set the Units to Architectural and inches. If your drawing is set up to architectural units each unit is an inch so use the ' mark to let ACAD know the length is to be multiplied by See ArchD 's reply above for how to enter feet and inch lengths.

The attached screencast shows how to draw the rectangle with Rectangle and PLine commands. A lot of people get formal training for using AutoCAD. If you want it to read your mind, wait a few years. That technology is not very far off. If you want answers, leave your predilections aside until you actually know what the program can do.

If you perform this as you do with a grid it doesn't layout correctly. Specifically, set the units to Architectural - precision 0 and inches. When you draw the rectangle, count the grid boxes and they in no way equal 12 and 15 or whatever you enter for dimensions.

The 12x15 unit rectangle shown below matches the grid. What are you seeing when you do it? Please attach your dwg file so we can help you better.

Try to think about what the program wants. It's a complex set of tools that you can do amazing things with. Place a point at one corner. Donnie, I have a case right this moment, where that is not true. Your email address will not be published. Learn how to get access. For help with your software contact our Certified Helpdesk.

US Survey Feet vs. September 12, 6 Comments. Share on facebook. Share on twitter. Share on linkedin. Share on pocket. Share on email. Have a Question About Civil 3D? Learn More. Popular posts like this. Leave a Comment Cancel Reply Your email address will not be published.

Become a Member Today. General Inquiries.