Autocad 2011 splines

Back to Topic Listing Previous Next. Filter by Lables. Failure while chamfering. Message 1 of Hello, i am using Autocad and i have a problem drawing splines. Also, i am working in cross-section view. Preview file. Message 2 of Hi, welcome forums. Hard to say anything by just seeing an image, can you upload the drawing?

CDay not an Autodesk consultant. Message 3 of I checked the line type and it's set as continuous. But, I mofified the clip of the section with my add-on Promine and it solved the problem.

Regards, Laurent. Message 4 of Message 5 of Message 6 of Thank you very much! Creates additional spline segments until you press Enter. Closes the spline by defining the last point to be coincident with the first. By default, closed splines are periodic, maintaining curvature continuity C2 along the entire loop. Controls whether the spline is created with fit points or with control vertices. Creates a degree 3 cubic B-spline by specifying fit points that the spline must pass through.

When the tolerance value is greater than 0, the spline must be within the specified tolerance distance from each point. Creates a spline by specifying control vertices. Use this method to create splines of degree 1 linear , degree 2 quadratic , degree 3 cubic , and so on up to degree Adjusting the shape of a spline by moving control vertices often provides better results than moving fit points.

Converts 2D or 3D quadratic or cubic spline-fit polylines to equivalent splines. The following prompts are specific to the fit point method. Turn on suggestions. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Showing results for.

Search instead for. Did you mean:. This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.

Converting Arcs and Splines to Segments?